Hmmm ... another ex workshop lead rack
USED
GENERIC BALANCED AUDIO LEAD
Balanced audio use
3 pin XLR Male ~ 3 pin XLR Female
Neither of the connectors have any identification ... they "look" similar to CANNON, with the rear rubber cable strain relief fitted
The male connector has Silver plated pins
Terminations are soldered on each connector, not IDC
The cable is two wire with a braid but I cannot find any ID stamping on the Black sheath.
5.5 metres lead length
6mm sheath OD
HOW IS IT CURRENTLY CONFIGURED?
XLR Straight through pin to pin (no crossovers etc)
Pin 1 - Ground-Shield (cable braid)
Pin 2 - RED Positive/Hot signal path
Pin 3 - WHITE Negative/Cold signal path
Measured capacitance: 33pF per foot (pretty good)
COSMETIC CONDITION:
USED
CLEAN
Both connectors are in good condition with no damage and all contact areas are clean.
I have now placed this audio lead into a clear, sealed plastic packet awaiting a new owner.
