Every piece of equipment powered via the single phase AC mains supply should have one of these installed.
Protects against line borne spurious voltage spikes, line noise and RF induced noise using an internal L-C filter.
These EMI Filters have all been extracted from various industry equipment, fully functional but used.
EMI FILTER BLOCK
All are IEC Male socket inputs
None have the in-built fuse(s)
There are number of different models, below is the list currently available. Once you have settled on one or more of these, just select the unit you would like from the list on this page
#1: CORCOM 1EEA1 F7530
Made in Mexico
Maximum 250V AC @ 1A
Filter: 2x 10mH L + 9000pF C + 2x 3000pF C
3x spade terminals
#2: CORCOM 3EC1
Made in Mexico
Maximum 250V AC @ 3A
Filter: 2x 2mH C + 2x 0.1uF C + 2x 0.003uF C + 1Meg resistor R
3x spade terminals
#3: SRE CA 6L
Country of origin unknown (not marked)
Maximum 250V AC @ 6A
Filter: 2x 0.85mH L + 2x 8200pF C + 2x 2800pF C
3x solder tag terminals (not spades)
#4: SCHAFFNER FN9222R-3-06
Made in Thailand
Maximum 250V @ 3A
Filter: 2x 2.5mH L + 2x 2200pF C + 0.1uF C + 1Meg R
3x spade terminals
#5: CORCOM 3EF8
Made in Mexico
Maximum 250V @ 3A
Filter: 2x 1mH L + 2x 2800pF C + 9000pF C + 1M5 Ohm R
Hard wired (no terminals) shortest being Active & Neutral @ 50mm length, Earth is 110mm length
COSMETIC CONDITION:
This applies to all of the EMI Filters offered
CLEAN
NO damage to any of the all metal bodies
Spade terminals have been cleaned of excess solder (if any was used)
Each EMI Filter has now been packed individually into sealed clear plastic packets, awaiting for a new purpose in life!
