Ex our workshop spare parts
These come in very handy, in fact are absolutely necessary, if you have a beautiful classic Power Amplier/Preamplifier combo where the two sections are separately available on the rear panel. This facility is found on the "better" amplifiers so that the user can either take off the pre-amp signal to a more desired power amplifer, or vice versa where the power amp if fine but a different preamp is desired or even to "split" the audio signal out to an additional one or more external power amps.
We kept spares of these bridging plugs around the workshop, sometimes folks would bring in an amp which was "not working" only to find that someone had removed these bridging plugs from the rear which of course leaves the amp "dead"
Pretty sure this particular set came from some NAD gear (our equipment of choice at one time) and most likely of Japanese origin.
UNBRANDED - Male RCA Silver Plated Patch Bridging Plug (Set Of Two)
Country of origin is not stated (nor a brand)
Most likely this is Japanese product (based on the equipment we used to deal with mainly)
Tough, dense Black plastic body with finger grip grooves
Silver plated pins 13mm x 3.2mm diameter
Pin spacing is 14mm centre to centre
COSMETIC CONDITION:
USED
Clean
NO damage to either of the pins or the body
NO markings of any kind on the body
This twin pack of bridging plugs has now been sealed into a clear plastic packet, ready to bring another PA-Preamp combo to life!
