USED Equipment "pull"
Ex ROHDE & SCHWARZ RF Test Equipment
Low loss RF lead/adaptor which is most often used for equipment internal RF module interconnects
Mil Spec SMB Plug with a short 350mm lead terminated with another right-angle Mil Spec SMB Plug
USED but fully functioning!
This RF interconnect lead is VERY SIMILAR to the 320mm interconnect lead I have advertised separately but the major difference is the coax used ... see below for details
Suitable for use up to around 4Ghz in amateur and commercial environments across many types of equipment e.g test cables, communications equipment and radio frequency test equipment and of course, custom projects!
UNIDENTIFIED MANUFACTURER - RF Interconnect Adaptor Lead
I strongly suspect this is Huber + Suhner product
R/A (right angle) SMB Female to R/A (right angle) SMB Female
MIL spec
All Gold plated metal
Coax type is unknown, definitely 50 Ohm (as all interconnects were 50 ohm impedance) but the coax is quite different and unfortunately completely unidentified. My memory is not great these days but I "think" this interconnect was at the signal generator output "business end" going to driver module/electronic attenuation system.
The coaxial cable sheath is light Grey and a larger diameter (4.5mm OD) than all of the other coaxial cable used on the interconnects (2.5mm OD) and the light Grey sheath is more "flexible" than the other coax, in fact it almost feels like a Silicon rubber.
Short lead at only 350mm length
No identification stamps or printing is visible on either the connectors or the coax except the W numbering on the heatshrink at each end of the lead. Those numbers are equipment manufacturer number codes, important as there are a LOT of these interconnect cables inside the equipment!
COSMETIC CONDITION:
USED
Clean/shiny connectors - no damage at all
Coax is completely undamaged - no kinks, cuts or other damage.
