NEW Old Stock
Ex our workshop stores which ceased operations some time ago (retired) and I now need to find new owners for this gear.
Great high quality British engineered pin chuck, holds the drill bit in a very tight, stable grip - no wobbles!
ECLIPSE 160 - Pin Chuck
Made in England (Sheffield)
Capacity 0.25 - 2.5mm
1/4" shank
Supplied with 3x collets (the bit that sits inside the chuck that grabs the drill bit)
Collet sizes: 0.25 – 0.75, 0.75 – 1.5, 1.5 – 2.5mm
In the original Blue box, I have opened the box to check the contents and condition.
Pin Chucks are used for the gripping of VERY small drill bits, mainly in lathes (tail stock) where the Pin Chuck does not revolve.
NOT recommended for hand drills, these pin chucks are most commonly used with a lathe
It can be very difficult to find these, I noticed that many suppliers in Australia are "Out Of Stock" but I found one offering these at A$107 the set HERE
I am not a dealer, happy enough to recover my original costs and just hoping to find a new owner for the masses of our other workshop bits & pieces - once this Pin Chuck is sold, there will not be any ongoing supply.
COSMETIC CONDITION:
NO RUST OR OXIDISATION OBSERVED
A little dirty inside the box so at some time in the dim dark past someone else has had a look inside!
All collets look fine (3x different sizes) with "like new" collet fingers on each
Smooth screw on section of the chuck
I have now resealed the outer box within clear plastic ready for a new owner
