HISTORY:
Sustainability is the name of the game! Anything (that has been tested and still functioning properly) should be repurposed creating saving in wasted Ee and reducing the poisoning our environment when items are buried in the earth at the local tip needlessly.
Never heard of Ee? It is a concept that creates a measurement of ALL things (not just electronics) that humans have made and the energy used in obtaining the raw material, processing the materials right through to a finished product and even should include the shipping of the item to the distributors/retailers.
If you would like to know more about Ee values, please take a look HERE
Ex workshop spare parts and small manufacturing stock - originally designed into some servo control products, position sensor.
BRAND NEW
Old Stock
ALL devices have been sourced through reputable local distributors such as RS Electronics, Farnell, WES and Rockby (Victoria)
This is no ordinary trim pot!
It is not just about the Gold plated legs (and I can see the plating extends inside to the wiper as well) but also precision tolerance AND these can be "group stacked"
What does "group stacking" mean?
In the centre, there is a sloted hole. By fitting a small plastic shaft into this hole you can mechanically control another (or more) trimmer pots at the same time, creating what is effectively a dual gang trimmer pot (or even tri-gang) with different trimmer values on each gang!
Ah (I hear you wondering), where do I get those small plastic shafts?
I found some! Take a look HERE
But wait there's more!
This trimpot has no "stops" i.e continuous rotation, perfect for position sensing
UNMARKED MANUFACTURER - Trimpot
NOTE: I am "pretty" sure these are actually BOURNS (USA) components
Made in Mexico
Model: Not sure! We ordered these as a "special" and I cannot see any references to this type of trimpot in the BOURNS contemporary catalogues.
Body colour: Black Plastic with White centre hole area
ID MARKINGS ON THE BODY:
Side (Light Grey printed):
U-2.5M-OHM
MEXICO E6
There are no further printed or stamped identifications on the body at all
Track resistance: 2.5M Ohm
Taper: Log (Because of the strange prefix, not A or B, in the part number I checked the taper - from across the entire track until around 50% it is linear in change and then for the remaining 50% of travel the trimpot rapidly drops towards zero i.e it is not linear.
Tolerance: +/- 5% or less!
Single rotation to move across the whole track
Continuous turn (no stop)
Slot centre adjustment from either side
Power rating: 500mW
Mounting: Vertical PCB using 12mm square pins (similar to wire-wrap posts)
DIMENSIONS:
15.85mm wide x 16.75mm height x 10.2mm deep
12mm PCB pins (Gold plated)
5.5mm pin spacing between any two of the three pins
Centre adjustment hole measures 3.5mm diameter (slotted)
COSMETIC CONDITION:
NEW Old Stock (in original packaging with legs inserted into foam for protection)
NO body damage
NO pin damage (straight)
TEST NOTES:
I measured quite a number of these trim pots to remind myself of their basic characteristics (it was a long time ago that we purchased and used these!)
Tested 75% of these trimmers (and then grew tired of it!) and ALWAYS the total track resistance tolerance never exceeded 5% variation.
Continuous rotation, there is no stop point. Wiper resistance SMOOTHLY (but in a log taper fashion) moves from zero to the full track resistance and then if rotation is continued, wiper resistance drops right back to zero again.
I am 95% sure that these are based on a plastic conductive/cermet track for high accuracy and reliablity.
*** Where the photograph shows multiple components, this advertisement is for ONE component not all that are shown!
