Ex workshop spare parts, time for me to find new owners of these components
USED
Very good condition
UNKNOWN MANUFACTURER - Alligator Clip (set of two)
These are NOT your junky alligator clips that I have seen being offered at a national retailer! The mouth does not move from side to side and the grip tension is tight but not too tight.
Terminal of the cable at the rear is NOT your usual "push down tab" arrangement but instead the core of the cable fits inside a very small "tunnel" with is soldered at the opposite end of the tunnel and if you really wanted to be thorough, sweat soldered inside the tunnel.
The exit from the connector has a solid (with centre hole) plastic plug, this provides cable support at the exit point.
Outer insulating plastic is flexible and yet strong, not prone to tearing.
DIMENSIONS:
Fully assembled: 59mm length
Boot: 15mm diameter x 47mm length
Jaw mouth maximum opening width: 8.5mm
"Tunnel" diameter for the insertion of new conductor core: 0.9mm
COSMETIC CONDITION:
USED
Clean
NO sideways movement to the jaw(s)
Soldering areas are clean and ready for the connection of a new cable
Stored and supplied in a sealed clear plastic packet of two (Red & Black boots)
