USED
Ex broadcast industry standard 19" subrack frame
Typically these aluminium rails are used to support heavier Eurocard/DIN 41612 slide in modules such as power supplies or AC transformer cards where a standard nylon or plastic guide rail may not support the weight of the card sufficiently.
Subframe hardware can be VERY expensive! Using these not only saves our planet's resources (re-using) but saves big money on your next subframe project!
UNKNOWN MANUFACTURER - Card Guide Rail (1)
These were extracted from either Vero or Schroff subrack frames but I cannot see any identification numbers at all on the component
This advertisement price is for one rail (in the interests of the greatest flexibility to the user) although in normal circumstances you would need two rails, one upper and one lower.
MATERIAL: high standard extruded raw Aluminium
DIMENSIONS:
TOTAL LENGTH: 200mm
Two mounting holes, one at each end of the rail
MOUNTING HOLE to HOLE: 180mm
MOUNTING HOLE DIAMETER: 3mm
A "locating dimple" is pressed into the Aluminium between the mounting hole and the rail end, 6mm between the hole and the dimple
The extrusion could be roughly described as an H shape but the upper section of the H is smaller than the lower section.
NORMAL ORIENTATION (mounting rail so that cards are inserted vertically)
Card sits 2.75mm down inside the card rail
Card rail width is 2mm
SIDEWAYS ORIENTATION (mounting the rail so that cards are inserted horizontally)
Card will now sit 3.75mm down inside the card rail
Card rail width is wider at 2.25mm
Each rail supplied with the two original mounting bolts which screw into the subrack framework
COSMETIC CONDITION:
USED
CLEAN
Straight and completely undamaged
Now individually packed into sealed clear plastic packets, with the 2x bolts
